The body responsible for naming this standards is the USB Implementers Forum or just USB-IF for short. On getting to the ‘3.’ marker of the USB standard, some confusion starts to set in. Initially when data speed of up to 5Gbps was achieved, it was named the USb 3.0 or SuperSpeed. Later on, data speed was doubled to 10Gbps and the former USB 3.0 was renamed to USB 3.1 Gen 1 while the new 10Gbps was designated as the USB 3.1 Gen 2 or otherwise the SuperSpeed+. To be clear, the numeric naming side here is not meant for consumers. Rather, the Hi-Speed, SuperSpeed and SuperSpeed+ designation is what is intended to be the consumer side of the naming. Moving on to USB 3.2, these was coined out on the arrival of the 20Gbps speed arrival making it an habit to rename once a new speed threshold is achieved. Anyway, the USB-IF changes the former USB 3.1 Gen 1 to USB 3.2 Gen 1 and USB 3.1 Gen 2 to USB 3.2 Gen 2. The new USB 3.2 Gen 1 still has a 5.0Gbps speed, the USB 3.2 Gen 2 with 10Gbps and the new standard with 20Gbps speed is named USB 3.2 Gen 2×2. However, the Gen 2×2 speed can only be delivered via a USB-C connector. This doesn’t mean every USB-C connector comes with such speed, USB-C is available for USB 2.0 standard and higher. The USB-IF have made quite an effort to confuse everyone about which is which as far as USB standards are concerned. In its own defence, USB- IF stated that the reason for this is ‘because it’s easier to absorb the earlier technologies into a broader USB 3.2 documentation so engineers have a single reference to check.’ USB-IF Chairman, Brad Saunders also adds that “They are exploring some improvements to target overall simplification.” We just hope this does not go on for too long and users are able to keep track of the evolving naming that’s taking place.
